Ultimaker Cura 4.8 Settings

Cette page rassemble les settings de Cura 4.8 : j'ai des problèmes de migration de la 4.2 (dernière stable à fonctionner correctement avec ma DE200) à la 4.8

Default Settings 4.8

Pour la 4.8 et la DE200, voici les settings de base :

Start G-Code :

;Begin Start Gcode for Dagoma DiscoEasy 200
;Sliced: {date} {time}
;Initial extruder: {initial_extruder_nr}

G90 ;Absolute positioning
M106 S255 ;Fan on full
G28 X Y ;Home stop X Y
G1 X100 ;Centre back during cooldown in case of oozing
M109 R{material_standby_temperature} ;Cooldown in case too hot
G28 ;Centre
G29 ;Auto-level
M104 S{material_print_temperature_layer_0} ;Pre-heat
M107 ;Fan off
G0 X100 Y5 Z0.5 ;Front centre for degunk
M109 S{material_print_temperature_layer_0} ;Wait for initial temp
M83 ;E Relative
G1 E10 F200 ;Degunk
G1 E-3 F5000 ;Retract
G0 Z3 ;Withdraw
M82 ;E absolute
G92 E0 ;E reset
G1 F6000 ;Set feedrate

;Finish Start Gcode for Dagoma DiscoEasy 200

End G-Code :

;Begin End Gcode for Dagoma DiscoEasy 200

M106 S255 ;Fan on full
M104 S0 ;Cool hotend
;M140 S0 ;Cool heated bed
G91 ;Relative positioning
G1 E-3 F5000 ;Retract filament to stop oozing
G0 Z+3 ;Withdraw
G90 ;Absolute positioning
G28 X Y ;Home
M109 R{material_standby_temperature} ;Wait until head has cooled to standby temp
M107 ;Fan off
M18 ;Stepper motors off

;Finish End Gcode for Dagoma DiscoEasy 200

Settings 4.2 (fonctionnent correctement)

Start G-Code :

TBD

End G-Code :

TBD